Important: Before First Use and After Filter Replacement
- Before first use, shut off the water supply, isolate electrical power where fitted and fully release system pressure. Open and inspect every serviceable cartridge housing, even if the unit arrives assembled. Cartridges may still be wrapped inside the housings. Remove all removable shipping packaging and plastic wrapping before fitting the cartridges. Leave permanent mesh, fabric, end caps and seals intact. Do not dismantle sealed inline or quick-change cartridges; remove only their external shipping packaging and specified protective port caps. Refit each cartridge in the correct position, seat the O-rings correctly and check for leaks when restarting.
- New carbon can release loose black carbon powder or dust. At first installation and after each carbon-cartridge replacement, flush the carbon stage to waste for several minutes until the water runs clean and clear, and complete any longer minimum flushing time or volume specified by the cartridge or system manufacturer. Do not drink the flushing water. If black particles persist after the specified flush, stop using the filter and contact H2O Warehouse for advice.
- Where carbon pretreatment is fitted upstream of an RO membrane, loose carbon fines can foul or block the membrane. Where the exact system manual and design permit, flush new carbon prefilters separately to waste before installing or replacing the membrane, or reconnecting the outlet to an existing membrane. Otherwise follow the model-specific assembled-system flushing procedure. Have a qualified installer confirm the correct flushing route if uncertain; do not improvise a bypass. Complete all required membrane and whole-system start-up flushing before use.
- Flushing removes loose material; clear water alone does not confirm that the water is safe to drink. Follow the system's feed-water, disinfection and commissioning requirements.
Premium DARLLY Replacement cartridges will fit any 3 Sage 20 inch Big Blue water filter system
Stage 1: 3x DARLLY meltblown sediment filter (5 Micron), removes mud, rust, dirt, floating particulates or any other large particles
Stage 2: 3x Carbon Block 800mg/g filter reduces fine sediment, chlorine taste and the concentration of heavy metals such as lead and copper
Stage 3: 3x DARRLY meltblown sediment filter (1 Micron), further removes contaminants, oils and up to 60% of bacteria
NOTE: Images are for reference purposes only, product visual may differ slightly.